![]() ![]() ![]() ![]() This is where you must specify the Penetration Height of each pipe connected to the tank.įor example, the return sprayers come in to the top of the cooling tower at 20 feet measured from the bottom of the tower. Liquid Level should be set to the level of the liquid as measured from the bottom of the tank, typically the basin depth (5 feet in the model shown above) for cooling towers. If the cooling tower is pressurized or under vacuum, the pressure (or vacuum) exerted on the surface of the liquid should be entered. Surface Pressure should be set to 0.0 psig if the cooling tower is open to atmosphere. Cooling Tower modeled in PIPE-FLO.Įlevation should be set to the elevation of the bottom of the basin of the cooling tower. The Curve dP Device in the pipe at the top of the tower represents the spray nozzle header just prior to it branching out to the six spray nozzles.įor an alternative method of modeling the spray nozzles, refer to Modeling a Spray Nozzle.įigure 2. Cooling Tower Design Calculation Software Software By UsingĬooling Tower Design Calculation Software Software By Using. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |